For Video Instructions, click here: Replacing the Clutch (Plastic) Step 1- Remove the handle from the handle rests and place the handle in the full forward position as shown. Step 2- Stand the WaterRower upright and disconnect the bungee as shown. Step 3- Lay the WaterRower down and slowly pull the handle so that …
For Video Instructions, click here: Replacing the Clutch (Plastic) Step 1- Remove the handle from the handle rests and place the handle in the full forward position as shown. Step 2- Stand the WaterRower upright and disconnect the bungee as shown. Step 3- Lay the WaterRower down and slowly pull the handle so that …
Position the handle forward to the front Forward Riser pulley Carefully remove the Top Deck by removing the Top Deck bolts and upper Tie Rods. Gently lift the Top Deck up being careful not to dislodge any of the guide pulleys. Unclip the sensor connector from the wire harness. Remove the footboard handle rests, and loosen …
Sensor Disk Replacement: View a video for this Step 1– Remove the Handle from the handle rests and place the handle in the full forward position as shown. Step 2- Stand the WaterRower upright and disconnect the bungee as shown. Step 3- Lay the WaterRower down. Remove the Tie Rods and JCB bolts connecting the Top Deck …
If your S4 monitor is flashing zeros and not counting down, there is one simple check you can do that may solve the problem. You can check the position of the Sensor Disk. During shipping of your WaterRower Tank this Sensor Disk can slide slightly downwards. The diagram below shows the position of the Sensor …
Step 1. Remove the tie rods and JCB bolts connecting the top deck to the tank assembly as shown. Step 2– Remove the top deck assemble as shown, being careful not to dislodge the guide pulleys. Step 3– Disconnect the Sensor Connector. Remove the old monitor retaining pin and remove the old monitor from the key …
Step 1- Remove screws (2) fastening the Battery Cover at the rear of the monitor as shown. Step 2– Remove the Battery Cover as shown. Step 3- Remove the Batteries as shown. Step 4– Replace the Batteries as shown. Step 5- Replace the Battery Cover as shown Step 6- Replace the screws (2) fastening the Battery Cover …
Step 1- Remove screws (2) fastening the battery cover at the rear of the monitor as shown. Step 2– Remove the Battery Cover as shown. Step 3- Remove the Battery as shown Step 4- Remove screws (4) fastening the Monitor Board Assembly to the housing as shown. Step 5- Remove Monitor Board Assembly as …
Step 1. With the 5mm Allen key, unscrew the seat stops. There are two on the front and back of each rail. Step 2. Peel the old extrusion off the rail. Step 3. Using alcohol, remove ALL the left over adhesive. Please do not use any other solvent as it may damage the paint. Step …
English
العربية
简体中文
繁體中文
Nederlands
Français
Deutsch
हिन्दी
Bahasa Indonesia
Italiano
日本語
한국어
Português
Русский
Español
Svenska
Tiếng Việt