Monitor S1 Service Instructions

S1: Monitor Board Replacement

  • May 23, 2017 // Modified 7 years ago

Step 1- Remove screws (2) fastening the battery cover at the rear of the monitor as shown.

Step 2– Remove the Battery Cover as shown.

Step 3- Remove the Battery as shown

Step 4- Remove screws (4) fastening the Monitor Board Assembly to the housing as shown.

 

Step 5- Remove Monitor Board Assembly as shown.

 

Step 6- Remove the Sensor Wiring Connector as shown.

Step 7- Replace Monitor Board as shown. Be care to ensure that yoyu place the Sensor Wiring Connector correctly. The connector should be oriented so that the red wire is toward the outside edge of the board.

Step 8- Replace Monitor Board assembly as shown.

 

Step 9- Replace screws (4) fastening the Monitor Board Assembly to the Monitor Housing as shown.

Step 10- Replace Batteries as shown.

 

Step 11- Replace the Battery Cover as shown.

 

Step 12– Replace the screws (2) fastening the battery cover at the rear of the monitor as shown.

Related Articles

  • Series 4: Cover Plate Replacement (push-button)

    Step 1– Press the Heel Rest adjustment button and remove the Heel Rests as shown. Step 2– Using the 5mm Allen Key provided with the machine, remove the Heel Rest...

  • S1: Wire Harness Replacement

    Position the handle forward to the front Forward Riser pulley Carefully remove the Top Deck by removing the Top Deck bolts and upper Tie Rods. Gently lift the Top Deck up...

  • S1: Recoil Belt Replacement (Clip On Recoil)

    For Video Instructions, click here: Replacing the Recoil Belt Step 1- Remove the handle from the handle rests and place the handle in the full forward position Step 2- Stand...

  • Series 4: Recoil Bushing Replacement

    Handle Removal Step 1- Remove the handle from the Handle rests and place the Handle in the full forward position.   Step 2- Stand the WaterRower upright and disconnect the...