Series 4 Service Instructions

Series 4: Heel Rest Replacement (Push-Button)

Step 1– Press Heel Rest Lock Button and remove Heel Rest/Footpads. You may need to use a card (credit card, etc.) to help remove the heel rests fully. Slide the card into the top of the coverplate and then remove heel rests.

Step 2– Press Heel Rest Lock Button and replace Heel Rest/Footpads

Related Articles

  • S1: Oilite Bearing Replacement

    Step 1- Remove the Handle from the handle rests and place the handle in the full forward position. Step 2- Stand the WaterRower upright and disconnect the bungee from the...

  • Series 4: Monitor Battery Replacement

    Step 1- Remove screws (2) fastening the Battery Cover at the rear of the monitor as shown.   Step 2– Remove the Battery Cover as shown.   Step 3- Remove the Batteries as...

  • Series 3: Oilite Bearing Replacement

    Step 1- Remove the Handle from the handle rests and place the handle in the full forward position. Step 2- Stand the WaterRower upright and disconnect the bungee from the...

  • Series 3: Level Gauge Location

    The Level Gauge sticker on all Series 4 (S4) model WaterRower units, is located on the side of the tank under the tank stopper.   The Level Gauge sticker on...