Series 4 Service Instructions

Series 4: Recoil Belt Buckle Replacement

Step 1- Pass the Recoil Belt through the bungee buckle with the belt facing the serrations on the buckle as shown.

 

Step 2- Pass the Recoil Belt through the D-ring and back through the bungee buckle as shown. The Recoil Belt should follow itself back through the buckle. It is advised that the loose end of the Recoil Belt be passed back through the last bar of the Recoil Buckle as shown.

 

Related Articles

  • Series 3: Rubber Feet Replacement

    Step 1- Locate the two sets of indentation guides on the bottom of the wooden rail. A:The rear rubber feet indentations are approximately 3 1/2” from the back of each...

  • Series 3: Monitor Troubleshooting

    Battery Replacement Your Series 3 WaterRower requires 4 (AA) batteries for monitor function. If your monitor does not power on, these batteries likely need replacing. The battery pack is located...

  • Series 4: Monitor Retrofit

    Step 1- Remove the handle from the handle rests and place the handle in the full forward position as shown.  Step 2- Stand the WaterRower upright and disconnect the bungee...

  • M1: Handle replacement (metal clutch)

    For Video Instructions, click here: Replacing the Handle Assembly (Metal/Velcro attachment) Step 1. Remove the Handle from the handle rests and place the handle in the full forward position Step 2. Stand...