For Video Instructions, click here: Replacing the Clutch (Plastic) Step 1- Remove the handle from the handle rests and place the handle in the full forward position as shown. Step 2- Stand the WaterRower upright and disconnect the bungee as shown. Step 3- Lay the WaterRower down and slowly pull the handle so that …
Position the handle forward to the front Forward Riser pulley Carefully remove the Top Deck by removing the Top Deck bolts and upper Tie Rods. Gently lift the Top Deck up being careful not to dislodge any of the guide pulleys. Unclip the sensor connector from the wire harness. Remove the footboard handle rests, and loosen …
If your S4 monitor is flashing zeros and not counting down, there is one simple check you can do that may solve the problem. You can check the position of the Sensor Disk. During shipping of your WaterRower Tank this Sensor Disk can slide slightly downwards. The diagram below shows the position of the Sensor …
Step 1. Remove the handle from the handle rests and place in the full forward position. Step 2. Stand the WaterRower upright and disconnect the bungee. Step 3. Lay the WaterRower down and pull the handle so the drive strap unwinds from the clutch housing. Remove the handle and drive strap from the clutch by unstrapping the …
Handle Removal Step 1. Remove the Handle from the handle rests and place the handle in the full forward position Step 2. Stand the WaterRower upright and disconnect the bungee from the recoil belt as shown Step 3. Lay the WaterRower down and slowly pull the handle so that the drive strap unwinds from the …
For Video Instructions, click here: Removing the Top Deck Step 1- Remove the handle from the handle rests and place the handle in the full forward position as shown. Step 2- Stand the WaterRower upright and disconnect the bungee as shown. Step 3- Lay the WaterRower down. Remove the Tie Rods and JCB bolts …
Step 1 – Remove the Handle from the handle rests and place the handle in the full forward position as shown. Step 2 – Stand the WaterRower upright and disconnect the bungee as shown. Step 3 – Lay the WaterRower down. Remove the tie rods and JCB bolts connecting the top deck to the tank assembly as shown. …
Step 1 – Remove the Handle from the handle rests and place the handle in the full forward position as shown. Step 2 – Stand the WaterRower upright and disconnect the bungee as shown. Step 3 – Lay the WaterRower down. Remove the tie rods and JCB bolts connecting the top deck to the tank assembly as shown. …
Step 1 – Remove the Handle from the handle rests and place the handle in the full forward position as shown. Step 2 – Stand the WaterRower upright and disconnect the bungee as shown. Step 3 – Lay the WaterRower down. Remove the tie rods and JCB bolts connecting the top deck to the tank assembly as shown. …
For video instructions, please see the following link: Replacing the Short Tank with Metal Clutch 1. Remove the handle from the handle rests and place in the full forward position. 2. Stand the WaterRower upright and disconnect the bungee. 3. Lay the WaterRower down and pull the handle so the drive strap unwinds from the …
English
العربية
简体中文
繁體中文
Nederlands
Français
Deutsch
हिन्दी
Bahasa Indonesia
Italiano
日本語
한국어
Português
Русский
Español
Svenska
Tiếng Việt