A1/GX Service Instructions

A1/GX: Forward Riser Replacement

For Video Instructions, please see the following link:
Replacing the Forward Riser Assembly

Step 1- Remove handle assembly (see handle removal replacement instructions)

Step 2- Remove Recoil Belt (see recoil belt replacement instructions)

Step 3- Remove Tie Rod bolts as shown.

 

Step 4- Remove the fasteners connecting the forward riser bottom bracket to the side rails as shown.

Step 5- Remove the forward riser assembly from the tank assembly as shown.

 

Step 6- Replace the forward riser assembly against the tank assembly and between the rails as shown.

 

Step 7- Replace the Tie Rod bolts as shown. Ensure that the cross dowels into which the Tie Rod bolts screw are aligned with the Tie Rods. To do this use a screwdriver to ensure that the cross dowel slot is in line with the cross dowel as shown.

 

Step 8- Fasten the forward riser bottom bracket to the side rails as shown.

 

Step 9- Replace the handle assembly (see handle replacement instructions)

Step 10- Replace the Recoil Belt (see recoil belt replacement instructions)

Related Articles

  • Series 4: Tank Reseal

    If your tank has sprung a leak, the best way to go about repairing it is with our Tank Glue Kit. We have full written instructions as well as a...

  • Series 4: Monitor Housing Replacement

    Step 1.  Remove the tie rods and JCB bolts connecting the top deck to the tank assembly as shown. Step 2– Remove the top deck assemble as shown, being careful not...

  • Series 3: Recoil Bushing Replacement

    Handle Removal Step 1- Remove the handle from the Handle rests and place the Handle in the full forward position.   Step 2- Stand the WaterRower upright and disconnect the...

  • Series 4: Rubber Feet Replacement

    Step 1- Locate the two sets of indentation guides on the bottom of the wooden rail. A:The rear rubber feet indentations are approximately 3 1/2” from the back of each...