A1/GX Service Instructions

A1/GX: Seat Carriage Replacement

  • May 19, 2017 // Modified 7 years ago

Step 1.  Stand the Indo-Row machine up and undo the bungee cord.

Step 2.  Using the 5mm Allen Key, undo the 2 back rear leg bolts.

Step 3.  Using the 5mm Allen Key undo the 2 back seat stoppers on either side of the monorail.

Step 4.  Slide the seat carriage off the rail.

Step 5.  Using the 5mm Allen Key, undo the 4 bolts on the seat carriage to remove the cushion.

Step 6.  Screw in the new seat carriage.

Step 7.  Before sliding the new seat carriage on, slide in one black rubber block on each side of the rail all the way to the front stoppers. Then slide the new seat back onto the monorail.

Step 8.  Replace the back seat stoppers.

Step 9.  Replace the rear leg.

Step 10.  Reconnect the bungee cord with the recoil belt.

Related Articles

  • M1: Recoil Bushing Replacement

    Handle Removal Step 1- Remove the handle from the Handle rests and place the Handle in the full forward position.   Step 2- Stand the WaterRower upright and disconnect the...

  • M1: Monitor Housing Replacement

    Step 1.  Remove the tie rods and JCB bolts connecting the top deck to the tank assembly as shown. Step 2– Remove the top deck assemble as shown, being careful not...

  • Series 3: Short Tank Assembly Replacement

    For video instructions, please see the following link: Replacing the Short Tank with Metal Clutch   1. Remove the handle from the handle rests and place in the full forward...

  • S1: Handle Replacement (metal clutch)

    For Video Instructions, click here: Replacing the Handle Assembly (Metal/Velcro attachment) Step 1- Remove the Handle from the handle rests and place the handle in the full forward position Step...