Series 4 Service Instructions

Series 4: Footboard Replacement

  • Apr 27, 2017 // Modified 7 years ago

Step 1– Remove the Handle from the handle rests and place the handle in the full forward position

Step 2– Remove the handle rest bolts and handle rests as shown.

Step 3– Remove side bolts fixing the foot board to the side rails as shown.

Step 4– Remove the foot board as shown.

Step 5– Replace the foot board as shown.

Step 6– Replace the Handle Rests and Handle Rest Bolts as shown. Do not Tighten the bolts yet.

Step 7– Replace the bolts fastening the foot board to the side rails as shown. When complete tighten all fasteners.

Related Articles

  • Series 4: Rubber Feet Replacement

    Step 1- Locate the two sets of indentation guides on the bottom of the wooden rail. A:The rear rubber feet indentations are approximately 3 1/2” from the back of each...

  • S1: Recoil Belt Replacement (Clip On Recoil)

    For Video Instructions, click here: Replacing the Recoil Belt Step 1- Remove the handle from the handle rests and place the handle in the full forward position Step 2- Stand...

  • Series 3: Monitor Troubleshooting

    Battery Replacement Your Series 3 WaterRower requires 4 (AA) batteries for monitor function. If your monitor does not power on, these batteries likely need replacing. The battery pack is located...

  • A1/GX: Handle Replacement (plastic clutch)

    For Video Instructions, click here: Replacing the Handle Assembly (Plastic – Bolt On)   Step 1- Remove the handle from the handle rests and place it in the full forward...