Series 4 Service Videos

Series 4: Replacing the Recoil Belt (Video)

Related Articles

  • Series 4: Monitor Sensor Disk Alignment

    If your S4 monitor is flashing zeros and not counting down, there is one simple check you can do that may solve the problem. You can check the position of...

  • Series 4: Rubber Feet Replacement

    Step 1- Locate the two sets of indentation guides on the bottom of the wooden rail. A:The rear rubber feet indentations are approximately 3 1/2” from the back of each...

  • Series 4: Clutch Replacement (Plastic)

    For Video Instructions, click here: Replacing the Clutch (Plastic) Step 1- Remove the handle from the handle rests and place the handle in the full forward position as shown.  ...

  • Series 4: HiRise Adapter Instructions

    Step 1 – Stand the WaterRower upright. Step 2 – Using a Phillip’s head screwdriver, remove all 16 Rail Bumpers and Rail Bumper screws from underneath the rails. Step 3 – Attach...