Replacement of the seat assembly is simple and the process is identical for any Hybrid Series rower. Follow the steps below.
Step 1
Stand the rower up and unclip the Bungee cord from the Recoil Belt.
Step 2
Using the 5mm Allen Key provided with your rower, undo the 2 Rear Leg bolts.
Step 3
Using the 5mm Allen Key, undo the 2 rear seat stoppers on either side of the monorail and slide the stoppers out. You may just have rubber stoppers — if so, slide the stoppers out.
Step 4
Slide the seat off the rail.
Step 5
At this time, use a cloth to clean the inside groove of the monorail that the wheels travel in.
Step 6
Attach the new seat carriage using the tools and hardware removed in Step 5.
Step 7
Before sliding the new seat on, ensure there is a rubber stopper on each side of the rail all the way to the front stoppers. Then slide the new seat onto the monorail.
Ensure that the V-shaped indentation of the set shown faces the rear of the rower.
Step 8
Replace the back seat rubber stoppers.
Step 9
Replace the rear leg.
Step 10
Stand the rower up and re-clip the Bungee cord to the Recoil Belt.