The black rubber feet on the rails of your Original Series rower may wear or crack with heavy use and age. Replacement of the feet is simple and the process is identical for any Original Series rower. Follow the steps below.
Step 1
Locate the front and rear feet on each rail.
The rear feet are approximately 3.5″ from the back end of each rail (near the rear spacer).
The front feet are approximately 13″ from the front end of each rail (under the tank).
Step 2
Stand the rower up on end.
Step 3
Using a Phillips screwdriver or a screw gun with a Phillips bit, remove the old rail feet and attaching screws.
Note: It may be easier to access the rear rail feet by standing on a chair.
Step 4
Install the new rail feet and screws. When securing them to the rail, tighten the screw just enough that the foot cannot rotate by hand. Do not overtighten as the feet will compress and not sit evenly.