1. Home
  2. Knowledge Base
  3. WaterRower Original
  4. Original - Monitor
  5. Original Series – Monitor: How to replace the monitor (S4 and S4 Bluetooth Monitors)
Searching...

Original Series – Monitor: How to replace the monitor (S4 and S4 Bluetooth Monitors)

Replacement of the monitor of your Original Series rower’s S4 Monitor or S4 Bluetooth Monitor is a relatively simple task to perform. Follow the steps below.

Diagram showing the R-clip and monitor assembly of an Original Series rower's S4 Monitor. Includes labeled connections and components.

Step 1

Remove the R-clip for old monitor. Please be careful of spring which will release when pin is removed.

Diagram showing the parts of the S4 monitor assembly including the monitor, retaining pin, spring, washer, and key bracket.

Step 2

Remove black washer, spring, and monitor from bracket.

Diagram of an Original Series rower's S4 Monitor attached to its bracket, illustrating the monitor's buttons and display.

Step 3

Insert new monitor through bracket on side.

Illustration showing the S4 monitor attached to its bracket, highlighting key connection points for installation.

Step 4

Put new spring with zip ties on spigot tube, followed by the black washer.

Illustration showing the R-clip and S4 monitor setup for an Original Series rower.

Step 5

Install R-Clip through the hole in spigot tube. You may need to pivot the monitor to accomplish this. Be wary of wires going down spigot tube. If you cannot get the R-Clip through, you may need to remove the bracket from the tank.

Diagram illustrating the removal of the R-clip from the bracket of a rower's monitor.

Step 6

Once R-Clip is all the way through, remove zip ties. These can be twisted off with pliers, or cut with scissors / wire snips.

Tagged:
Was this article helpful?
Yes No

Related Articles