Replacement of the tank cover on your Metallic Series rower is simple to do. Follow the video and steps below:
Step 1
Place handle into the most forward position near the large pulley in the Forward Riser.
Step 2
Using the 5mm ratchet included with your rower, remove the handle rests and handle rest bolts. Set them aside.
Step 3
Rotate the footboard away from the tank assembly toward the rear of the rower.
Step 4
Remove the old tank cover by sliding it simultaneously upward and toward the rear of the rower.
Step 5
Install the new tank cover by sliding it simultaneously downward and toward the front of the rower. If your rower is equipped with black plastic shims to secure the front end of the top cover, ensure the cover is fully seated in them.
Step 6
Rotate the footboard forward towards the tank and align the handle rest holes with the nuts embedded in the black angled brackets of the tank assembly.
Step 7
Using the 5mm ratchet, reinstall the handle rests and their bolts.
Do not overtighten these bolts as damage to the black angled brackets may occur.
Note: Do NOT use a drill or impact driver when when installing these bolts.